Tel:0533-4297566 

中文  |  English  |  Español   

Copyright © 2019 Shandong Zhuocheng Pump  Co., Ltd.   All Rights Reserved.

CONTACT US

Shandong Zhuocheng Pump  Co., Ltd.

Contact:Mr.chen

Phone:15552694444

Tel:0533-4297566

E-mail:zhuochengzhenkong@126.com

Address: North of Xiyucheng Village, Boshan Economic Development Zone, Zibo, Shandong,China

QR code

 NEWS CENTER

>
News Details

What are the components of the stainless steel water ring vacuum pump?

The stainless steel water ring vacuum pump is mainly used for the formation of a rough vacuum. Because of its advantages of close to isothermal compression, insensitivity to dust, inhalation of gas can entrain liquid or large amount of water vapor, it is widely used in electric power, petrochemical, pharmaceutical, papermaking and other fields.

The stainless steel water ring vacuum pump is mainly used for the formation of a rough vacuum. Because of its advantages of close to isothermal compression, insensitivity to dust, inhalation of gas can entrain liquid or large amount of water vapor, it is widely used in electric power, petrochemical, pharmaceutical, papermaking and other fields.

In most applications, stainless steel water ring vacuum pumps use water as a working fluid, which is often referred to as a stainless steel water ring vacuum pump. There are many different configurations in all stainless steel water ring vacuum pump products on the market.

1 According to the structure of the parts of suction and exhaust, it can be divided into cone pump and flat pump.

2 According to the number of stages of the impeller, it can be divided into single-stage pump and double-stage pump. Among them, the cone pump and the flat pump have a single-stage impeller and a two-stage impeller structure. 3 According to the suction and exhaust process points completed per revolution of the impeller, it can be divided into single-acting and double-acting vacuum pumps.

In the above several vacuum pumps of different structures, each pump is composed of a pump shaft, a pump body, a side cover, an impeller, a distribution plate (plate pump) or a distributor (cone pump), a shaft seal member, a bearing component, and the like. . Parts that come into contact with the working medium during work are called overcurrent parts, and the remaining parts are called non-overcurrent parts.